Gasser HotRod Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,490 Posts
Discussion Starter · #1 ·
Some or most of you know what Murphy's Law is; "You never know when or where but Murphy is going to break something or find the most inconvenient time to make something a pain in the b*&t." If you were following the fiberglass thread you know I have been waiting on air compressor parts. I got them, even read the instructions (sort of) after all, I did just take it apart. Tried to put the first connecting rod/piston in and crap it won't go on the shaft from the electric motor. Back to the instructions. Tap shaft lightly with rubber mallet to loosen. Ok, tap tap, comes out. At that point I realize the gouge I saw in the shaft (that I didn't think was a seperate piece) now looks way worse than when it was attached. So back to the internet and order a new shaft. Waiting on USPS again. Murphy you suck!!!!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top