Gasser HotRod Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
203 Posts
Discussion Starter · #1 ·
Is anyone brave enough to be working on an aluminum Ultra-High Compression Oldsmobile engine and in need of some nice heads or a stock four barrel intake? Maybe a sweet stock distributor or timing cover? Anything else? I have a nice engine, broken down completely but complete that I'll sell the parts and pieces off of, or the whole assembly if you need.

Give you a nice deal, like to see these parts used.

Also have a very nice four barrel aluminum intake from the aluminum head small block Buick 300 from the early 60's. Pretty rare as it only came on the high compression engines and only for a few years at that.

Again, I'll offer a good deal if you can use for yourself or a friend and not just eBay them off.

I had BIG plans, now . . . not so much.

The parts are located in Kingston, MA 02364

Thanks,

TC
 
1 - 1 of 1 Posts
Top