[1937Austin]

Appears you're setup for push-pull steering, not cross steer. Speedway Motors sells a 2" offset steering arm for the Ford spindles.

2 Inch Drop Ford Upper Steering Arm

This 2" drop steel steering arm fits '37-'48 Ford style spindles. It is tapered to accept an 11/16" tie rod end. Designed for use on upper spindle mount in "traditional steering" set-ups using a reversed Corvair, '48-'56 Ford pickup, or '68-'73 Mustang steering box.

www.speedwaymotors.com

 

[1937Austin]

Yes


Thank you Austin for help. That is exactly what I need.

Sorry you are correct push pull steering, ment to put that in original post.

It states on speedway that the hole is tapered to accept a tie rod end not a heim end. Could you see it being an issue if I ran a heim end???

I've used them with a heim, but they will need to be drilled out to 5/8" diameter to fit the heim. The tapered small end is usually about 1/2", so needs to be opened up.

 

[1937Austin]

Must be a bit tougher to build a gasser over on your side of the pond?