Gasser HotRod Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
77 Posts
Discussion Starter · #1 ·
Getting the motor mounts today, had to fab up some angle plate,...( SBC, volare front clip, f-100)...working on finishing the mock up for motor and trans mounts..and then onto the steering. Chyrsler really like LARGE steering boxes! A guy can drop a buck to to hook up his steering column
 

·
Registered
Joined
·
105 Posts
Yeah ditto on the pics.... I have always wanted a Unibody
 

·
Registered
Joined
·
77 Posts
Discussion Starter · #5 ·
some pics.

Haven't try to post pics here, so, no guarantee.....got the basics of the motor mounts going...all lined up...ready for weld. Got some 1/4 x 1" stock to use as support gussets to minimize flexing. Had to go with the speedway face plate...as you can tell from the one pic...ABSOLUTELY NO ROOM around that steering box to utilize stock mount position. All in All ...pleased with the out come thus far. Gotta tell ya...had a tech rep from a very reputable hot rod shop tell me that if I have problems around the steering box...to just "MOVE" the engine over a few inches to get the right clearance!...What?....Appears I have just enough clearance around the spline shaft to fit the "u" joint...Hope to not have to "generate " clearance on the header...appears..I am incapable of loading a picture
 

·
Administrator
Joined
·
13,532 Posts
Most of us use a Photobucket free account to load pics, then paste them into our posts here. There's a tutorial in the Lobby chat area if you need some info Bob.
 
1 - 6 of 6 Posts
Top