I used my hydraulic ram for years. This was stuff i had around the shop, been using for the last few time, found it is much faster and easier to strighten your frame. I had some 5/8 all thread and four coupling nuts. These grip ends i got at Home depot, but you can weld a couple nuts or pipe on a 4 inch piece of 2 inch angle iron, to do the same thing.
I used a 6 inch C Clamp, and a 3/4 or 1" Bender, EMT or Pipe. Hold the area you don't want to bend, with the all thread. Them bend with the bender, see attachment. If you have any questions, e-mail me at gasserted@yahoo.com If you don't want to spend 2 or 300. bucks for a Hydraulic Bender, i found it was much easier and faster. Good Luck.
Make sure you box in you frame when done. Willys frame rails are not strong. Must be boxed, racing it or not....
I used a 6 inch C Clamp, and a 3/4 or 1" Bender, EMT or Pipe. Hold the area you don't want to bend, with the all thread. Them bend with the bender, see attachment. If you have any questions, e-mail me at gasserted@yahoo.com If you don't want to spend 2 or 300. bucks for a Hydraulic Bender, i found it was much easier and faster. Good Luck.
Make sure you box in you frame when done. Willys frame rails are not strong. Must be boxed, racing it or not....