Great hot rod material....!!!! take a few inch's off the top.. tub the back...wait for it.....wait for it....wait for it....a big block..........and...
Here's one that showed up on Facebook Marketplace. A 1940 Austin A8 2 dr. The seller says "only two known" which isn't correct. I've been in contact...
Vall I would lose the flex fan...if thats an early unit they are only good for 8,000 RPM and throw blade pieces...crack at the rivets...had one that...
When they clear up the city streets from homeless, drug addicts, rodents, disease, and whatever else may be sleeping at the curbside then they should...
We're so outnumbered here in Oregon that the only conservative candidate who has a good chance of holding office is in the Eastern side of the state....
Mario the bracket I bent up has the odd angled bend needed to straighten up the bracket from the fender angle. So when I bent it I didn't make a full...
I'm curious what this guy's prices are? Toyed with the thought of calling him just to ask, or at least maybe sending a message to ask prices. But hen...
I will, and I'll also put sheet metal behind it before I weld just to keep it from blowing out. I can grind off whatever doesn't stick afterwards on...
"I post the work on my hotrod, not because it's the best way, rather it was the way I had to get it done with the resources I had.................
Of which I might be an encouragement to other hotrodders".
Find latest posts
